Installation And Setup (For The Network Connected Models) - Panasonic DP-2310 Operating Instructions Manual

Installation and Setup (For the Network Connected Models)

For the Network Connected Models
Panafax Desktop uses the fax modem in the Panasonic/Panafax models connected on your network (LAN)
for fax communication.
Before using the Panafax Desktop, it is necessary to activate the Fax Modem and to setup certain
parameters. Follow the steps below to setup the Panafax Desktop.
Installation
1 Confirm the following device settings.
Send Only System settings:
Connection to the network
Set Internet parameters:
- IP Address
- Subnet Mask
- Default Gateway IP Address
Set Fax Parameters:
- Set the Relay XMT Report = off (Fax Parameter No. 143)
Send & Receive System settings:
Connection to the network
Set Internet parameters:
- IP Address
- Subnet Mask
- Default Gateway IP Address
- Email Address
- Email Server Name/IP Address
Set Fax Parameters:
- Set the Relay XMT Report = Always (Fax Parameter No. 143)
- Set the Fax Forward to Receive Email Account (Fax Parameter No. 054)
2 Install the Document Management System.
Refer to the Installation section of this Operating Instruction.
Note:
For the DP-1810F/DP-1810F (Network PC Fax) DP-2000/2310/2500/3000/3010/3510/3520/4510/4520/6010/
6020, the Panafax Desktop does not install automatically with the TYPICAL installation. Select CUSTOM
installation and check the Panafax Desktop to be installed.
There is both a Parallel connection and Network connection Panafax Desktop for the DP-1810F. The model name
of DP-1810F (Network PC Fax) is selected when using the Network version of Panafax Desktop and DP-1810F is
selected when using the Local (Parallel) version of Panafax Desktop.
Panafax Desktop
139