Installation And Setup Of Panafax Desktop - Panasonic WORKIO DP-3510 Operating Instructions Manual

Panafax Desktop

Installation and Setup of Panafax Desktop

Panafax Desktop uses the fax modem in the Panasonic/Panafax models connected on your network (LAN)
for fax communication.
Before using the Panafax Desktop, it is necessary to activate the Fax Modem and to setup certain
parameters. Follow the steps below to setup the Panafax Desktop.
Installation
1 Confirm the following device settings.
• Common settings:
- Connection to the Network
- Setup the IP Address setting
- Setup the Relay XMT Password
• Send Only System settings:
- Set the Relay XMT Report = Invalid (Fax Parameter No. 143)
• Send & Receive System settings:
- Set the Relay XMT Report = Valid (Fax Parameter No. 143)
- Set the Fax Forward to Receive Email Account (Fax Parameter No. 054)
2 Install the Document Management System.
Refer to Page xx
Note:
For the DP-3510/4510/6010, the Panafax Desktop does not install automatically with the TYPICAL installation.
Select CUSTOM installation and check the Panafax Desktop to be installed.
110