Table of Contents
Advertisement
Appendix2. How to check the WindowsNT network software
The TCP/IP protocol in WindowsNT must be installed in order for the ClipCopy application to
be run. Whether this protocol has been installed can be checked by following the steps
below.
If it has not been installed, consult your dealer.
1. Exit all applications, and click the Start button on the WindowsNT task bar. (See Fig. 1
and 2.) If the task bar is not on the screen, move the cursor near the bottom of the dis-
play, and the task bar will appear below the display area.
2. Move the cursor to [Settings] in the Start menu. (See Fig. 3.) Click the Control Panel item
from the pop-up menu.
Fig. 1
Fig. 2
44
Advertisement
Table of Contents
