Using A Battery Pack Made By Anton Bauer; Using The Np-1B Battery Pack Made By Sony - Panasonic DVCPRO AJ-D410AP Operating Instructions Manual

Preparation
Using a battery pack made by
Anton Bauer
Before use, charge the battery pack using the exclusive battery
charger made by Anton Bauer.
For the charging time and other details, refer to the operating
instructions of the battery charger used.
1
Attach the battery pack made by Anton
Bauer.
Power output connector for lighting
Battery pack made by Anton Bauer
<Reference>
A battery holder made by Anton Bauer is equipped with a power
output connector for the lighting and a lighting control switch to
enable a light to be easily attached. For details on the lighting
systems available, contact Anton Bauer.
2
Insert the battery pack and slide it in the
direction of the arrow.
Release lever
<Reference>
To remove the battery pack, slide it in the opposite direction to the
one in which it was attached while keeping the release lever on the
battery holder pulled down all the way.
3
Set the battery type.
Select the battery type using <BATTERY> on the sub-menu
screen.
Example: Select "NiCd13" if the TRIMPAC13 is to be used;
select "NiCd14" if the TRIMPAC14 is to be used.
(See page 36)
Lighting control switch
2
Using the NP-1B battery pack
made by Sony
Before use, charge the battery pack using the exclusive battery
charger made by Sony.
For the charging time and other details, refer to the operating
instructions of the battery charger used.
1
Remove the battery holder.
Refer to step 1 on page 10.
2
Attach the battery made by Sony to the
unit.
3
1
Mounting
connector for
NP-1B
First, remove the battery holder cover.
1 Attach the mounting connector for the NP-1B.
2 Use the mounting screws to mount the battery case.
3 Tighten the screw for the power supply contact.
4 Insert the top of the cover in the direction of the arrow.
5 Align the hole in the bottom of the cover (metal part) with the
hole in the bottom of the battery case, and attach using the
screw provided with mounting connector for NP-1B.
3
Set the battery type.
Select the battery type using <BATTERY> on the sub-menu
screen.
Select "NiCd12" if the NP-1B is to be used. (See page 36)
11
Battery case
2
4
Cover
5
Screw provided
with mounting
Hole
connector for
NP-1B