Panasonic DVCPRO AJ-D410AP Operating Instructions Manual page 8

Parts and their functions
B
A
@
?
>
=
<
; : 9
1
Viewfinder connector
The viewfinder plug is connected to this connector.
2 CC/ND filter selector knob
This is used to select the filter to match the subject brightness.
1 :3200K
2 :5600K+1/8ND
3 :5600K
4 :5600K+1/64ND
3
Lens lever
This lever is tightened to secure the lens after the lens has been
attached to the lens mount.
4 Lens mount (bayonet type)
The lens is attached to this mount.
5
AUTO W/B (white/black) BAL switch
AWB: The white balance is automatically adjusted. When the
AWB memory selector switch on the side panel is set to A
or B and then the AUTO W/B BAL switch is operated, the
adjustment value is recorded in the memory. Bear in
mind that the switch does not work when it is set to the
ATW or PRST position.
ABB: The black balance is automatically adjusted.
6 SHUTTER switch
This is the ON/OFF selector switch of the electronic shutter.
OFF : The electronic shutter does not operate.
ON : The electronic shutter operates.
SEL : This is used when the electronic shutter speed is to be
changed. The switch is a non-locking type. The shutter
speed changes each time it is operated. For further
details, refer to "Electronic shutter settings" (page 21).
7 VTR START/STOP button
This starts or stops the video recording.
8
LENS jack (12-pin)
The connecting cord of the lens is connected to this jack. For
further details on the lenses that can be used, refer to the
operating instructions of the lenses concerned.
C
D
1
2
3
4
5
6
7
8
8
9 MIC IN (mic input) jack (XLR, 3-pin)
The accessory microphone is connected to this jack. The power
for the microphone is supplied from this jack.
:
S-VIDEO OUT jack (Y/C jack)
When pictures are to be recorded with a backup VTR connected
to the S-VIDEO OUT jack, bear in mind that the unit's playback
pictures will be recorded onto the backup VTR if any operation
(such as REC CHECK) that performs VTR playback is
executed.
;
AUDIO OUT jacks (pin jacks)
An audio component is connected to these jacks. The sound for
channel 1 and channel 2 is output separately.
<
CAM OUT jack
This is the dedicated output jack for the camera's pictures.
= GENLOCK IN connector (BNC)
Supply the sync signal (black burst signal) to this connector
when gen-locking the camera pictures (CAM OUT jack) of the
unit.
>
TC OUT connector (BNC)
This is connected to the TC IN connector on the external VTR
when the time code of an external VTR is to be locked to the
time code of this unit.
?
TC IN connector (BNC)
The time code serving as the reference is input to this connector
when the unit's time code is to be locked to the time code of an
external component.
@
ECU (remote control) connector (6-pin)
The AJ-EC3P extension control unit (optional accessory) is
connected to this connector.
A
Built-in wireless slot
The wireless receiver (optional accessory) can be attached
here.
B Light shoe
The video light or other such device is attached here.
C Shoulder belt fittings
The shoulder belt is attached here.
D
Viewfinder stopper screw
This screw is used to secure the viewfinder.