When Using The Headset; Changing The Ringing Tone Of A Co Button; Volume Control - Handset Receiver/Headset/Ringer/Speaker - Panasonic KX-TD308 User Manual

1.1

When using the headset

The Panasonic Digital Super Hybrid System supports the use of a headset with a
proprietary telephone (PT). When you use the headset (optional), you should switch the
selection mode first. Selection is explained in the "Handset/Headset Selection" in Station
Programming (Section 2).
To change to the headset mode
Press: [PROGRAM] [9] [9] [9] [2] [STORE] [PROGRAM].

Changing the ringing tone of a CO button

There are eight ringer frequencies available for each CO (Loop-CO, Single-CO) button.
If you wish to change them, refer to the "Ringing Tone Selection for CO Buttons" in
Station Programming (Section 2).
Volume Control — Handset Receiver/Headset/Ringer/Speaker
Allows you to adjust the following volumes as required.
— Handset Receiver volume (levels 1 through 4)
— Headset volume (levels 1 through 4)
— Ringer volume (levels 0 through 3)
— Speaker volume (levels 1 through 12)
If your digital proprietary telephone is provided with a display (display DPT), the volume
level is indicated on the display by the number of asterisks. For ringer volume adjustment,
three levels (OFF/LOW/HIGH) are available with the KX-T7420 and KX-T7425.
To adjust the handset receiver volume
1
2
Configuration
1. Lift the handset.
2. Rotate the Jog Dial in the desired direction.
• The display shows:
<Example>
Handset:***
• You may also adjust the handset receiver volume during a
conversation using the handset receiver.
(— volume level 3)
DPT Overview
1-19