Bottom Base Assembly - Packard Bell EasyNote W3 Series Disassembly Manual

2. Remove the screws (2xK) from the side ODD bracket and remove it.
3. Remove the screws (2xK) from the rear ODD bracket and remove it.
Fig. 19

Bottom Base Assembly

Disassemble the bottom base assembly as follows:
1. Remove the screws (15xJ, 3xG, 2xB) from the bottom base.
2. Remove the screws from the rear (2xB).
3. Remove bottom cover from base assembly.
4. Disconnect the subwoofer connector.
5. Remove the screws (2xG) and lift out the subwoofer assembly.
6. Remove the rubber stabilizers (2xM) from the subwoofer assembly.
7. Remove the screw (1xB) from the modem connector board.
The screws of the optical disk drive brackets.
Fig. 20
The bottom base assembly.
Fig. 21
The screws at the bottom base rear.
11