For Vigor2820Vn - Draytek Vigor2820 Series User Manual

1 . 2 . 4 F o r V i g o r 2 8
1 . 2 . 4 F o r V i g o r 2 8
LED
ACT (Activity)
USB
CSM
WLAN
DSL
Left LED
WAN 2
(Green)
Right LED
(Green)
Line
Phone 1/2
LED on Connector
Left LED
LAN
(Green)
1(Giga)
Right LED
(Green)
Left LED
LAN
(Green)
2/3/4
Right LED
(Green)
Left LED
WAN 2
(Green)
Right LED
(Green)
2 0 V n
2 0 V n
Status Explanation
Blinking The router is powered on and running normally.
Off The router is powered off.
On A USB device is connected and active.
Blinking The data is transmitting.
On The profile of CSM (Content Security Management) for
IM/P2P application is enabled from Firewall >> General
Setup. (Such profile is established under CSM menu).
On
Wireless access point is ready.
Blinking
It will blink while wireless traffic goes through.
On The router is ready to access Internet through DSL link.
Blinking Slowly: The DSL connection is ready.
Quickly: The connection is tranning.
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 100Mbps.
Off The port is disconnected with 10Mbps.
On A PSTN phone call comes (in and out). However, when the
phone call is disconnected, the LED will be off about six
seconds later.
Off There is no PSTN phone call.
On The phone connected to this port is off-hook.
Off The phone connected to this port is on-hook.
Blinking A phone call comes.
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
Off The port is disconnected with 10/100Mbps.
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 100Mbps.
Off The port is disconnected with 10Mbps.
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 100Mbps.
Off The port is disconnected with 10Mbps.
9
Vigor2820 Series User's Guide