Load-Balance Policy - Draytek Vigor2820 Series User Manual

3 . 1 . 6 L o a d - B a
3 . 1 . 6 L o a d - B a
This router supports the function of load balancing. It can assign traffic with protocol type, IP
address for specific host, a subnet of hosts, and port range to be allocated in WAN1 or WAN2
interface. The user can assign traffic category and force it to go to dedicate network interface
based on the following web page setup. Twenty policies of load-balance are supported by this
router.
Note: Load-Balance Policy is running only when both WAN1 and WAN2 are activated.
Index
Enable
Protocol
WAN
Src IP Start
Src IP End
Dest IP Start
Dest IP End
Dest Port Start
Vigor2820 Series User's Guide
l a n c e P o l i c y
l a n c e P o l i c y
Click the number of index to access into the load-balance policy
configuration web page.
Check this box to enable this policy.
Use the drop-down menu to change the protocol for the WAN
interface.
Use the drop-down menu to change the WAN interface.
Displays the IP address for the start of the source IP.
Displays the IP address for the end of the source IP.
Displays the IP address for the start of the destination IP.
Displays the IP address for the end of the destination IP.
Displays the IP address for the start of the destination port.
64