For Vigor2820Vn - Draytek Vigor2820 Series Quick Start Manual

1 . 1 . 3 F o r V i g o r 2
1 . 1 . 3 F o r V i g o r 2
LED
ACT (Activity)
USB
CSM
WLAN
DSL
WAN2
Line
Phone 1/2
LED on Connector
Left LED
LAN 1(Giga)
(Green)
Right LED
(Green)
Left LED
LAN 2/3/4
(Green)
Right LED
(Green)
Left LED
WAN 2
(Green)
Right LED
(Green)
8 2 0 V n
8 2 0 V n
Status
Blinking
Off
On
Blinking
On
On
Blinking
On
Blinking
On
Blinking
On
Off
On
Off
Blinking
On
Off
Blinking
On
Off
On
Off
Blinking
On
Off
On
Off
Blinking
On
Off
Explanation
The router is powered on and running normally.
The router is powered off.
A USB device is connected and active.
The data is transmitting.
The profile of CSM (Content Security Management) for
IM/P2P application is enabled from Firewall >>
General Setup. (Such profile is established under CSM
menu).
Wireless access point is ready.
It will blink while wireless traffic goes through.
If ACT and WLAN LEDs blink simultaneously when
WPS is working, and it will return to normal condition
after two minutes. (You need to setup WPS within 2
minutes.)
The router is ready to access Internet through DSL link.
Slowly: The modem is ready.
Quickly: The connection is training.
The router is ready to access Internet through WAN
connection.
It will blink while transmitting data.
A PSTN phone call comes (in and out). However, when
the phone call is disconnected, the LED will be off
about six seconds later.
There is no PSTN phone call.
The phone connected to this port is off-hook.
The phone connected to this port is on-hook.
A phone call comes.
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 1000Mbps.
The port is connected with 10/100Mbps.
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 100Mbps.
The port is connected with 10Mbps.
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 100Mbps.
The port is connected with 10Mbps.
6