Operation - Dimplex CUH05B31T Owner's Manual

Heater Installation
4. Remove junction box cover of
CUH and remove one knockout
hole. Insert approved bushing
into hole and feed wire cable
through. Tighten bushing around
cable.
5. Make electrical connection to
CUH according to relevant wire
diagram. Make connections

Operation

Setting the Thermostat
1. Before connecting or
disconnecting the power, turn unit
off by turning knob fully counter
clockwise. (see FIGURE 4)
2. Heater is equipped with
a thermostat. To adjust
temperature to your individual
requirements, turn thermostat
control knob clockwise all
the way to turn heater on.
When room reaches desired
temperature, turn thermostat
knob counter clockwise until
you hear a click. Leave in
this position to maintain room
temperature at this setting. For
additional heat, turn clockwise
until you hear a click again and
heater will turn on. To turn heater
to lowest setting, turn thermostat
knob counter clockwise all the
way.
using approved wire nut
connectors and secure the
grounding wire to the ground
screw on the heater chassis.
6. Replace junction box cover of
CUH.
Figure 4: Thermostat Control
Knob
LOW
HI
7