Electrical Connection - Dimplex CUH05B31T Owner's Manual

Heater Installation
direction from center, and tilted in a
45 degree range while suspended
from the wall or ceiling.
!
NOTE: The hardware for
mounting the hanger bracket to the
wall or ceiling is not included.
CAUTION:
or tilting the heater do not block the
exhaust opening.
The following steps are shown in
Figure 3:
1. Locate a stud or other suitable
support and install hanger
bracket on wall or ceiling. select
location so control knob on back
of heater can be reached easily. *
2. Insert carriage bolt into square
opening of heater handle.
3. slide spacer over the carriage
bolt shaft and insert in hanger
bracket opening and hold them in
position.
4. slide lock washer and thread
Figure 2
6
When turning and/
nut onto carriage bolt, turn and
tighten with wrench.
* Do noT InsTaLL LEss THan 6
FEET (1.9m) FRoM THE FLooR

ELECTRICAL CONNECTION

 W ARNINg: Consult local electri-
cal codes in addition to the follow-
ing requirements:
1. Turn off main power supply at the
electrical panel.
2. Route supply wires from circuit
breaker to an approved junction
box, located near compact unit
heater. Each heater should be
on an individual, properly fused
circuit.
3. Route supply wires from junction
box to CUH. supply wires from
junction box to heater must be
two conductor metallic sheath
(BX) cable with ground wire.
alternatively, appropriate conduit
can be used.
Figure 3
www.dimplex.com