Volvo S60 Owner's Manual page 326

08 Maintenance and service
Battery
NOTE
Tighten the screws to 30 Nm. Check the
torque with a torque wrench.
Fitting
1. Lower the battery into the battery box.
2. Move the battery inward and to the side
until it reaches the rear edge of the box.
3. Tighten the clamp that holds the battery.
4. Connect the ventilation hose.
> Check that it is correctly connected to
both battery and outlet in the body.
5. Connect the red positive cable.
6. Connect the black negative cable.
7. Press in the rear cover. (See Removal).
08
*
326
Option/accessory, for more information, see Introduction.
8. Fit the rubber moulding. (See Removal).
9. Align the front cover and secure it with the
clips. (See removal).
For more information on the car's main battery
- see page 364
Eco Start/Stop DRIVe*
Cars with the Start/Stop function are equipped
with two 12 V batteries - one extra powerful
battery for starting and one standby battery
that helps during the Eco Start/Stop DRIVe
function's starting sequence.
For more information on Start/Stop - see
page 123.
For more information on the car's main battery
- see page 114 and 364.
Battery Start
Cold start 760
B
capacity ,
CCA (A)
C 278×175×19
Size ,
L×W×H 0
(mm)
Capacity 70
(Ah)
A
The values do not apply to the standby battery in cars with
D3 engine and automatic gearbox.
B In accordance with the SAE standard.
C Largest possible size.
NOTE
•
The higher the current take-off in the car
(extra cooling/heating, etc.) the more
the batteries must be charged =
increased fuel consumption.
•
When the capacity of the battery has
fallen below the lowest permissible level
then the Start/Stop function is disen-
gaged.
Temporarily reduced Start/Stop function due
to high current take-off means:
A
Support
120
150×90×106
8