Hardware Installation - Vivotek FE8171V User Manual

Hardware Installation

Opening Dome Cover
First, use the included T20 hex key stardriver to loosen the four screws and detach the dome
cover from the camera base. Follow the steps below to install the camera either to a ceiling or a
wall.
Connect the supplied power &
i
IO cables if your switch does
not support PoE.
Rubber Stopper on the
Hole for Power & IO
Cables
Rubber Seal Plug
for RJ45 Ethernet
Cable
Tamper-proof Screw
Dome Cover Retainer
Dome Cover Retainer
VIVOTEK
User's Manual - 9