Vivotek IP8361 User Manual page 8

VIVOTEK
Hardware Reset
Reset Button
Status LED
The reset button is used to reset the system or to restore factory defaults. Sometimes resetting
the system can return the camera to normal operation. If the system problems remain after
reset, restore the factory settings and install again.
Reset: Press and release the recessed reset button with a paper clip or thin object. Wait for the
Network Camera to reboot.
Restore: Press and hold the recessed reset button until the status LED rapidly blinks. It takes
about 30 seconds. Note that all settings will be restored to factory default. Upon successful
restore, the status LED will blink red during normal operation.
SD/SDHC Card Capacity
This network camera is compliant with SD/SDHC/SDXC 16GB / 8GB and other preceding
standard SD cards.
8 - User's Manual