Selecting Setup Mode - Fostex VR800 Owner's Manual

Follow the steps below to select the desired SETUP menu in SETUP mode.
1. While the VR800 is stopped, press the SETUP key
on the control panel.
Pressing the SETUP key causes the VR800 to enter SETUP
mode. The VR800 displays the first hierarchy level of
the SETUP menu you selected before you turned off the
power. At this time, the menu graphics appear as shown
below.
The flashing menu indicator is the currently-selected
menu. Turning the JOG dial will select a different menu
and the corresponding menu indicator will flash.
2. Select the desired menu using the JOG dial, then
press the EXECUTE/YES key.
The VR800 displays the second hierarchy level of the
selected SETUP menu, where you can set parameters.
(Refer to the next page for more information.)
To exit SETUP mode, press the STOP button or the EXIT/
NO key. Each time you press one of these keys, the VR800
returns to the previous hierarchy level of the menu, and
finally exits SETUP mode.
The following diagram shows the position of each menu.
"Bk Format ?" menu
"Format ?" menu
VR800 Owner's Manual (Changing the initial setting: SETUP mode)

Selecting SETUP mode

"Tempo Set ?" menu
"Sign. Set ?" menu "Title Edit ?" menu
"Save PGM ?" menu
"NOs Event ?" menu
"Load PGM ?" menu
The title of the SETUP menu
appears. You can select a different
menu via the JOG dial.
This indicates the position of the SETUP menu. Selecting a
menu via the JOG dial will move the flashing cursor.
Note:
With the factory initial settings, or when you turn on the
power again after you format an external SCSI disk, "Sign. Set?
(Setting a time signature)" appears. Otherwise, the first hierarchy
level of the previously-selected SETUP menu appears.
"Del PGM ?" menu "Preroll ?" menu
"Click ?" menu
"
Resolu ?" menu
"Device ID ?" menu "Digi. out ?" menu
89
This lights up when the VR800
enters SETUP mode.
44.1kHz
DIGITAL
SETUP
SYNC OUT
CLK
AUTO
"Sync Out ?" menu
"Frame Rate ?" menu
"Mtc Offset ?" menu
"Ofset Mode ?" menu
"Slave Mode?" menu
"Slave Type?" menu
"Rec Protect ?" menu
"Digi. in ?" menu
DRIVE
SCSI
A.PUNCH