1. Manuals
  2. Brands
  3. Fostex Manuals
  4. Recording Equipment
  5. VR800
  6. Owner's manual

Saving And Loading Song Data Via A Scsi Drive - Fostex VR800 Owner's Manual

Fostex digital multitracker recorder owner's manual vr800
Hide thumbs Also See for VR800:
Table of Contents

Advertisement

VR800 Owner's Manual (Saving and Loading Song Data)
When the load operation is completed, [COMPLETED !]
lights up. The VR800 displays the top of the Program in
the current drive and stops.
11. Stop playing the DAT (or adat).
12. Press the EXIT/NO key or the STOP button.
[COMPLETED !] disappears.

Saving and loading song data via a SCSI drive

This section explains how to save and load data to and from a SCSI backup drive and a 3.5-inch E-IDE hard disk.
Recording mode on the current drive does not affect this operation. Refer to the "Saving and loading song data
between two SCSI drives" for more information on the procedure.
Connect a SCSI backup drive (ID #=6) to the SCSI connector on the 3.5-inch hard disk in the VR800, as shown below.
<Note on connections>
Be sure to connect a SCSI backup drive to the SCSI connector. Make sure that the ID number for the SCSI backup
drive is set to "6."
SCSI backup drive
(ID# = 6)
Note:
As shown in the drawing, when the SCSI drive assigned for the current drive is daisy chained to the SCSI drive for
backup and also connected to an 3.5-inch E-IDE hard disk which is in the current drive mode, please note the following items.
Backup SCSI drive
When the 3.5-inch E-IDE hard disk is assigned as the current drive:
Switch on power to VR800 only and not to the two SCSI drives connected.
If save/load of song data is to be executed using the SCSI drive assigned for backup, switch on power to the VR800 and the
SCSI drive assigned for backup. Do not switch on power to the SCSI drive assigned for the current drive. By utilizing either
method, VR800 will always recognaize the 3.5-inch E-IDE hard disk as the current drive.
In order to use the SCSI drive as the current drive, power to any equipment that is interconnected must, of course, be
switched on. The SCSI drive will automatically switch to the current drive mode.
Load
Save
WORD OUT
SCSI
OPTICAL
VR800 with a 3.5-inch E-IDE hard disk
Current SCSI drive
86
DATA
MIDI
OUT
IN
OUT
IN
AC IN
POWER
DATA
MIDI
WORD OUT
SCSI
OUT
IN
OUT
IN
OPTICAL
VR800 with a 3.5 inch E-IDE hard disk
AC IN
POWER
Show Quick Links

Hide quick links:

Advertisement

Table of Contents
loading

Related Manuals for Fostex VR800

Related Content for Fostex VR800

This manual is also suitable for:

Vr800z

Table of Contents