Table of Contents
Advertisement
X6DAL-B2/X6DAL-TB2 User's Manual
2-2
Xeon EM64T Processor and Heatsink Installation
When handling the processor package, avoid placing direct
pressure on the label area of the fan. Also, do not place the
!
motherboard on a conductive surface, which can damage the
BIOS battery and prevent the system from booting up.
IMPORTANT: Always connect the power cord last and always remove it
before adding, removing or changing any hardware components.
sure that you install the processor into the CPU socket before you install
the CPU heatsink.
install the Xeon mounting plate under the board.
Installing the CPU Mounting Plate
(*Note: CPU Retention Brackets are
pre-installed.)
1. Place the CPU retention bracket
on top of the CPU mounting plate.
2. Install the CPU mounting plate
below the retention bracket on the
reverse side of the motherboard.
3. Properly place the CPU on top of
the CPU socket. Align Pin 1 on the
CPU with Pin 1 on the CPU socket.
CPU Installation
1. Lift the lever on the CPU socket:
lift the lever completely as shown
on the picture on the right;
otherwise, you will damage the
CPU socket when power is
applied.
(Install CPU1 first.)
Note that for the X6DAL-B2/X6DAL-TB2 you need to
CPU Socket
Motherboard
Mounting Plate
2-2
Mounting Holes
w/Standoffs
Xeon CPU
CPU Socket
CPU Retention
Bracket
CPU Mounting
Plate
Heatsink
Make
Heatsink
Mounting
Holes
CPU
Socket lever
Advertisement
Table of Contents
