Chassis Mac Server (Cms) Commands - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

39 Chassis MAC Server (CMS)
The Chassis MAC Server (CMS) manages MAC addresses on the switch. The MAC addresses managed
via the CMS are used as identifiers for the following functions:
•
Base chassis MAC address
•
Ethernet Management Port (EMP)
•
VLAN router ports
Similar to IP addresses, MAC addresses are assigned by the Internet Assigned Numbers Authority (IANA)
and distributed to users in sequential blocks. A sequential block of MAC addresses is referred to as a MAC
address range.
The MAC address range is stored on the switch's EEPROM. The switch supports one MAC address range
only. By default, this MAC address range contains thirty-two (32) factory-installed, contiguous MAC
addresses.
MIB information for the Chassis MAC Server commands is as follows:
Filename: AlcatelIND1MacServer.MIB
Module: Alcatel-IND1-MAC-SERVER-MIB
A summary of the available commands is listed here:
mac-range eeprom
show mac-range
show mac-range alloc
OmniSwitch CLI Reference Guide March 2011
Commands
page 39-1