Basic Operations; Turning On The Cd Receiver; Adjusting The Volume; Selecting The Input Source - Onkyo CR-325UKD Instruction Manual

Basic Operations

STANDBY indicator
STANDBY/ON
PHONES INPUT

Turning On the CD receiver

CD receiver
To turn on the CD receiver, press the [STANDBY/ON]
button on the CD receiver or remote controller. The
STANDBY indicator goes off.
Press the [STANDBY/ON] button again to set the CD
receiver to Standby. The STANDBY indicator lights up.
Tip:
When you start playback on (or turn on) an Onkyo RI Dock,
MD recorder, or cassette deck that's connected to the
receiver
with an cable and analog audio cable, the CD
receiver turns on automatically. Similarly, when you set the
CD receiver to On or Standby, the other component will also
be set to On or Standby.

Adjusting the Volume

CD receiver
Turn the [VOLUME] control clockwise to increase the
volume or counterclockwise to decrease it.
You can also use remote controller's VOLUME [ ]/[ ]
buttons.
VOLUME

Selecting the Input Source

You can select CD, DAB, AM, FM, or a connected com-
Remote
ponent (TAPE, DOCK, USB) as the input source.
controller
To select the input source, press the remote controller's
INPUT [
receiver, press the [INPUT] button repeatedly. The input
sources are selected in the following order.
• CR-525UKD
• CR-425UKD/CR-325UKD
CD
*1 Input Display can be changed (see page 27).

Using Headphones

Turn down the volume, then connect your stereo head-
Remote
phones to the PHONES minijack.
controller
You can adjust the volume and mute the sound, as
explained earlier.
The speakers output no sound while the headphones are
connected.
STANDBY/ON
]/[ ] buttons repeatedly. On the CD
CD DAB
DOCK USB
CD DAB
DOCK
PHONES jack
INPUT
/
VOLUME
/
AM
FM
1
*
TAPE
FM AM
1
*
TAPE
25