Onkyo CR-325UKD Instruction Manual page 56

Using the Timers—Continued
7 If you selected "Once", use the
Previous and Next [
buttons to select the day, and then
press [ENTER].
You can select: SUN, MON, TUE, WED,
THU, FRI, or SAT.
Go to step 10.
8
If you selected "Every", use the
Previous and Next [
buttons to select the day, "Every-
day", or "Days Set", and then
press [ENTER].
You can select the following:
MON
SUN
9
If you selected "Days Set", use the
Previous and Next [
buttons to select the first day, and
then press [ENTER].
Use the Previous and Next [
[
last day, and then press [ENTER].
You can select only consecutive days.
10
Use the Previous and Next [
[
time, and then press [ENTER].
You can also use the remote controller's
number buttons to enter the time. For
example, to enter 7:29, press [7], [2], and
[9].
Notes:
• Once the On time is set, the Off time is
automatically set to one hour later.
• To ensure that the first few seconds of a
program are recorded when using timer
recording, set the On time slightly ahead
of the program's start time (about 1
minute).
56
]/[
]/[
TUE WED THU
Days Set Everyday
]/[
] buttons again to select the
] buttons to specify the On
11
]
12
]
FRI
SAT
]
13
CD receiver
]/
Remote
controller
]/
To return to step 1 and start timer programming all over
again, press the [MENU/NO] button at any point in this
procedure.
Use the Previous and Next [
[ ] buttons to specify the Off
time, and then press [ENTER].
If you selected "Play" in step 2,
Use the Previous and Next [
[ ] buttons to specify the CD
receiver's volume level, and then
press [ENTER].
The default setting is 10.
If you want to use your normal volume
level setting for the timer, press the Pre-
vious [ ] button repeatedly until
"TimerVol.Off" appears on the display.
In this case, the timer will use the volume
level that was set before the CD receiver
was set to Standby.
TIMER indicator 1, 2, 3, or 4 will
stop flashing and light up.
TIMER indicator
Underscore indicates
timer programmed for
recording
Press the [STANDBY/ON] button
to set the CD receiver to Standby.
Notes:
• Be sure to set the CD receiver to Standby,
otherwise the timed operation will not
work.
• While a timed operation is in progress,
you can cancel it by pressing the
[TIMER] or [SLEEP] button.
• While timed recording is in progress, the
output of the CD receiver is muted. To
hear what's being recorded, press the
[MUTING] button. Press it again to mute
the CD receiver.
• Memory, random, and 1-Folder playback
cannot be used with the timers.
]/
]/
Number of
programmed
timer