Basic Operations
STANDBY indicator
STANDBY/ON
PHONES
INPUT
Turning On the CD receiver
CD receiver
To turn on the CD receiver, press the [STANDBY/ON]
button on the CD receiver or remote controller. The
STANDBY indicator goes off.
Press the [STANDBY/ON] button again to set the CD
receiver to Standby. The STANDBY indicator lights up.
Tip:
When you start playback on (or turn on) an Onkyo RI
Dock, MD recorder, or cassette deck that's connected to
the CD receiver with an u cable and analog audio
cable, the CD receiver turns on automatically. Similarly,
when you set the CD receiver to On or Standby, the other
component will also be set to On or Standby.
Adjusting the Volume
CD receiver
Turn the [VOLUME] control clockwise to increase the
volume or counterclockwise to decrease it.
You can also use remote controller's VOLUME [q]/[w]
buttons.
VOLUME
Selecting the Input Source
You can select CD, AM, FM, or a connected component
Remote
(TAPE, DOCK, USB) as the input source.
controller
To select the input source, press the remote controller's
INPUT [t]/[1] buttons repeatedly. On the CD
receiver, press the [INPUT] button repeatedly. The input
sources are selected in the following order.
• CR-525
• CR-325
*
Using Headphones
Turn down the volume, then connect your stereo head-
phones to the PHONES minijack.
Remote
You can adjust the volume and mute the sound, as
controller
explained earlier.
The speakers output no sound while the headphones are
connected.
STANDBY/ON
CD
FM
DOCK
CD
FM
DOCK
Input Display can be changed (see page 27).
PHONES jack
INPUT
/
VOLUME
/
AM
*
USB
TAPE
AM
*
TAPE
25