Connecting An Onkyo Md Recorder - Onkyo CR-325UKD Instruction Manual

Connecting Other Components—Continued

Connecting an Onkyo MD recorder

The following diagram shows how to connect an optional Onkyo MD recorder.
Connect the CD receiver's MD/TAPE OUT jacks to the MD recorder's INPUT (REC) jacks, and connect the CD
receiver's MD/TAPE IN jacks to the MD recorder's OUTPUT (PLAY) jacks.
CD receiver's
What can you do with
• Connecting an Onkyo MD recorder to the CD receiver with an
the CD receiver's remote controller. In addition, when playback is started on the MD recorder, the CD receiver will
automatically select it as the input source.
• To use , you must connect the Onkyo MD recorder to the CD receiver with an
(RCA). In addition, the Input Display for the MD/TAPE jacks must be set to "MD" (see page 27).
• Some -capable components have two
is for connecting additional
Notes:
• When listening to the audio of a component connected to the CD receiver but with no
source.
• It is also possible to connect the
Display to "DAT" (see page 27).
• The MD/TAPE IN jacks can be connected to the audio output jack of a VCR. The VCR video output jack should be con-
nected to a TV. When the CD receiver is connected to a VCR, set the Input Display to "VIDEO" (see page 27).
22
rear panel
Red
White
Analog audio cables (RCA)
White
Red
the Onkyo MD recorder
: Signal flow
?
-capable components.
MD/TAPE jacks to a DAT recorder. When connected to a DAT recorder, set the Input
cable supplied with
cable allows you to control the MD recorder with
jacks. They're both the same, so you can use either one. The extra jack
Onkyo MD recorder's
rear panel
INPUT OUTPUT
(REC) (PLAY) REMOTE
CONTROL
L
R
White Red Red White
cable and an analog audio cable
connection, select TAPE input