Connecting An Onkyo Md Recorder - Onkyo CR-715 Instruction Manual

Connecting an Onkyo MD recorder

The following diagram shows how to connect an optional Onkyo MD recorder.
Connect the CD receiver's MD/TAPE OUT jacks to the MD recorder's INPUT (REC) jacks, and connect the CD
receiver's MD/TAPE IN jacks to the MD recorder's OUTPUT (PLAY) jacks.
CD receiver's
rear panel
LINE 1
I N
OUT
MD/
TAPE
I N
OUT
DOCK/
CDR
I N
R
What can you do with
• Connecting an Onkyo MD recorder to the CD receiver with an
the CD receiver's remote controller. In addition, when playback is started on the MD recorder, the CD receiver will
automatically select it as the input source.
• To use , you must connect the Onkyo MD recorder to the CD receiver with an
(RCA). In addition, the Input Display for the MD/TAPE jacks must be set to "MD" (see page 27).
• Some -capable components have two
is for connecting additional
Note:
• The MD/TAPE jacks can alternatively be used to connect a VCR or DAT recorder, in which case the Input Display
on the CD receiver would need to be set to "VCR" or "DAT" respectively (see page 27).
Connecting Other Components—Continued
Red
White
Analog audio cables (RCA)
White
Red
L
cable supplied with
the Onkyo MD recorder
?
jacks. They're both the same, so you can use either one. The extra jack
-capable components.
Onkyo MD recorder's
rear panel
INPUT OUTPUT
(REC) (PLAY)
L
R
White Red Red White
cable allows you to control the MD recorder with
cable and an analog audio cable
REMOTE
CONTROL
19