Olivetti d-Copia 16 Operation Manual page 79

5
Press the [Enter] key.
The display will return to that of Step 2.
Inch specifications
Custom Size (1 to 2)
Set the Custom Size.
The setting of Custom Size 1 is shown here as an example. To set
Custom Size 2 select F23 in the Default Settings Mode and then
perform the same settings.
1
Display the Default Settings Mode. (Refer to P.6-11
"Default Settings Mode Operations Procedures".)
Inch specifications
2
Press either the Zoom (+) or Zoom (–) key to display "F22".
Inch specifications
3
Press the [Enter] key.
Inch specifications
Metric specifications
Metric specifications
Metric specifications
Metric specifications
Section 6 COPIER MANAGEMENT
4
Press either the Zoom (+) key or the Zoom (–) key and select
the size.
InP (Irregular Size) When selecting Irregular Sizes, carry
out the following procedure. In the case of the selection of
other sizes, proceed to Step 9.
Inch specifications
5
Press the [Enter] key.
Inch specifications
6
Press either the Zoom (+) or Zoom (–) key and input the
Length Size (Y Direction) in inch/mm units.
Inch specifications
7
Press the [Enter] key.
Inch specifications
Metric specifications
Metric specifications
Metric specifications
Metric specifications
6-23