Dlp-6 Updating Atlas Firmware Using Tftp - ADTRAN ATLAS 800 SERIES System Manual

DLP-6 Updating ATLAS Firmware using TFTP

Introduction
The ATLAS 800 Series supports firmware updates via the 10/100 B
from a network server or the A
follow for a successful firmware upgrade using the 10/100 B
Tools and Materials Required
• A PC with a Telnet client software
• A TFTP Server accessible on the local network (A TFTP server is provided with the unit as part of the
ADTRAN Utilities software.)
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Electronic modules can be damaged by static electrical discharge. Before handling modules,
wear an antistatic discharge wrist strap to prevent damage to electronic components. Place
modules in antistatic packing material when transporting or storing. When working on
modules, always place them on an approved antistatic mat that is electrically grounded.
TFTP Instructions for Updating Firmware
1. Connect to the ATLAS using the 10/100 B
unit's E
port using Telnet client software, use the procedure in DLP-4, Verifying
THERNET
Communications Over an IP LAN, on page 324 to connect to the unit.)
2. Login to the unit using the read-write password (see DLP-5, User Access and Password Security
Levels, on page 327 for details).
3. Go to the S
YSTEM
4. Select the M
ODULE
Select S 0 to update the System Controller.
LOT
5. Go to the T
RANSFER
6. Enter the IP address of the network TFTP server into the TFTP S
7. Enter the full path name and filename of the update file into the TFTP S
61200780L1-1C
or C
DMIN RAFT
U menu and select the U
TILITY
S menu and press <Enter>. Select the appropriate module slot to update.
LOT
M menu and select TFTP.
ETHOD
© 2004 ADTRAN, Inc.
ASE
interfaces using XMODEM. This DLP provides the steps to
T Ethernet port and a TFTP Server.
ASE
T interface. (If you are not already connected to the
ASE
F
PDATE IRMWARE
T Ethernet port using either TFTP
menu; press <Enter>.
IP A
field.
ERVER DDRESS
F
ERVER ILENAME
field.
329