1.
INTRODUCTION
This section discusses the installation process for the ATLAS 800 Series System.
2.
TOOLS REQUIRED
The tools required for installation of the ATLAS include the following:
•
#2 Phillips-head screwdriver
•
Flat-head screwdriver (for installing modules)
To prevent electrical shock, do not install equipment in a wet location or during a lightning
storm.
Electronic modules can be damaged by static electrical discharge. Before handling modules, wear
an antistatic discharge wrist strap to prevent damage to electronic components. Place modules in
antistatic packing material when transporting or storing. When working on modules, always place
them on an approved antistatic mat that is electrically grounded.
3.
UNPACKING AND INSPECTING THE SYSTEM
Each ATLAS is shipped in its own cardboard shipping carton. Open the carton carefully and avoid deep
penetration into the carton with sharp objects. After unpacking the unit, inspect it for possible shipping
damage. If the equipment has been damaged in transit, immediately file a claim with the carrier, then
contact ADTRAN Customer Service (see the contact information in the front of this manual).
Contents of ADTRAN Shipment
Table 1 lists the items included in your ADTRAN shipment. Customers must supply a DB-9 male console
cable for VT100 terminal/terminal emulation connection and an Ethernet cable.
Table 1. Items Included in ATLAS Shipment
Item Description
Either the ATLAS 830 or the ATLAS 890 base unit
The ATLAS System CD
AC Power cord - ADTRAN P/N 3127031 (with AC systems)
19" Rackmount brackets and screws
61200780L1-1C
ATLAS 830
© 2004 ADTRAN, Inc.
ATLAS 890
One Base Unit
n/a
58