Dlp-2 System Login And Menu Access - ADTRAN ATLAS 800 SERIES System Manual

DLP-2 System Login and Menu Access

Introduction
After connecting to the ATLAS via either a VT100 terminal or a PC configured as a VT100 terminal, you
must login to the system to gain access to the management and provisioning functions (menus). This DLP
provides specific steps for system logon and menu access.
If the IP has been provisioned (see DLP-3,
on page 322), you can also login to the unit using Telnet.
Prerequisite Procedures
Complete DLP-1,
Connecting the Terminal or PC to the ADMIN or CRAFT Port
Tools and Materials Required
• Data cable to connect to a VT100 terminal or a PC configured as a VT100 terminal.
• VT100 terminal or PC configured as a VT100 terminal.
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Electronic modules can be damaged by static electrical discharge. Before handling modules,
wear an antistatic discharge wrist strap to prevent damage to electronic components. Place
modules in antistatic packing material when transporting or storing. When working on
modules, always place them on an approved antistatic mat that is electrically grounded.
61200780L1-1C
Setting IP Parameters for the ATLAS 800 Series System,
© 2004 ADTRAN, Inc.
, before logging in.
319