Table of Contents
Advertisement
MX2800 STS-1 User Manual
1.
NETWORK INTERFACE
Select Network Interface to access the network configuration parameters
MX2800 STS-1 network settings appropriately for the application.
Menu-option descriptions are described in the following sections:
•
STS-1 Configuration
•
Protection Configuration
•
Miscellaneous
on page 3-8
•
External Clock Configuration
STS-1 Configuration
Use the STS-1 Configuration selections described below to configure the STS-1 network settings to match
an application.
Line Length
Set the line length to reflect the physical length of the STS-1 network line, as follows:
• Set the line length to
• set it to
if the distance is less than 225 feet
Short
Timing
This option determines the source of timing used to derive the transmit signal. The MX2800 STS-1 has
four modes of timing operation:
61204659L1-1A
Figure 3-5. Network Configuration Menu
on page 3-5
on page 3-7
on page 3-8
if the cabling distance is between 225-450 feet
Long
Configuration, Section 3
Network Interface
(Figure
3-5). Configure the
3-5
Advertisement
Table of Contents
