Miele CVA 4085 Operating And Installation Manual page 72

Problem solving guide
72
^ Buff the contacts a little, e.g. with fine glasspaper or emery
cloth.
^ If this fault message continues to appear, please call the
Miele Service Department.
. . . the machine does not rinse through when switched on,
even though the Automatic rinsing programme is set to
"On".
If the temperature of the machine is still above 60 °C, rinsing
cannot take place.
. . . water stopped flowing whilst programming in the
amount to use.
Water flow stops automatically when the maximum fill quantity
is reached. The maximum quantity is stored in memory.
There is insufficient water in the water container (when using
the water container and not the plumbed in water supply).
The quantity used previously was not saved to memory.
. . . there is water in the waste container.
This is not a fault. The water is left over from the brewing and
cleaning process.
. . . there is a lot of residual "coffee water" in the waste
container.
If the slide control for the grinder is set to very fine, too much
residual "coffee water" can be left in the waste container.
^ If a very fine grinder setting has not been set, call the Miele
Service Department.
. . . the descaling process was started by mistake.
The descaling programme cannot be cancelled once you
have touched the "OK" sensor. The programme has to be
completed through to the end. This is a safety measure to
ensure that the machine is fully descaled, and is important to
protect the machine and ensure it functions correctly.