Operation; Rapid Ignition System; Switching On, Adjusting The Flame And Switching Off - Miele CS 1011 Operating And Installation Instructions

Rapid ignition system

The appliance has a rapid ignition
system with the following features:
– Rapid ignition without pressing und
holding the control
– Automatic re-iginition
Should the flame be extinguished by
a gust of air, the burner will re-ignite
automatically.
If re-ignition is unsuccessful, the gas
supply will be cut off automatically
(see "Safety cut-off").
Switching on, adjusting the
flame and switching off
The control is used to ignite the burner
and to regulate the strength of the
flame.
ß The gas supply is turned off
& Strongest flame
Both the inner and the outer burners
operate on full output.
& (2x) Strong flame
The outer burner operates on low
output and the inner burner on high
output.
/ Weak flame
The outer burner is switched off, and
the inner burner operates on high
output.
/ Weak flame
The outer burner is switched off,
The inner burner operates on low
output.
The burner can only be switched on
by pressing in the control and
turning it anti-clockwise. It is
switched off by turning the control
clockwise. The outer flame ring can
only be switched on and off by
pressing down on the control and
turning it the appropriate way.
The following will cause damage to
the appliance:
- Switching the burner on without
pressing the control down,
- Switching the burner on by
turning the control clockwise,
- Switching the outer flame ring
on or off without pressing the
control down,
- Switching the burner off by
turning the control
anti-clockwise.
The manufacturer will not accept
liability for any damage resulting
from incorrect operation.

Operation

23