To Change The Small Jets - Miele CS 1011 Operating And Installation Instructions

Conversion to another type of gas
To check the first intake of air
a Adjusting screw
b Air intake sleeve
Gap X must measure:
For natural gas:
For liquid gas:
To set gap X
^ Loosen screw a and adjust air intake
sleeve b. Then retighten screw a.
56
6 mm
13 mm

To change the small jets

a Small diameter jet
(e.g. for liquid gas: 0.23)
b Large diameter jet
(e.g. for liquid gas: 0.60)
^ Using a small screwdriver, unscrew
the two small jets a and b in the gas
fitting.
^ Pull out the jets with a pair of pliers.
^ Fit the correct jets securely (see jet
table).
^ Finally, secure the jets against
inadvertent loosening with sealing
wax.