Changing The Insert Location Of The Insert Effect; Selecting The Patch For The Insert Effect - Zoom MRS-8 Operation Manual

Each effect module in an algorithm comprises two
aspects, namely the effect type and the effect parameters.
Even within the same algorithm, changing the effect type
and/or the effect parameters can produce a variety of
different sounds.
Patch
PRE AMP/
COMP
DRIVE
MODULATION/
EQ
DELAY
The edited effect type and parameter settings are stored as
a so-called "patch". The insert effect allows 20 - 50
patches per algorithm. The numbers are listed in the table
below.
Number of patches
Algorithm
(preprogrammed patches)
CLEAN 30 (22)
DIST 50 (42)
ACO/BASS SIM 20 (10)
BASS 20 (10)
MIC 50 (31)
LINE 50 (30)
DUAL MIC 50 (30)
MASTERING
30 (21)
To use a patch, first select the algorithm and then select
one of the patches in the algorithm. When you select a
patch, it becomes effective immediately.
Changing the insert location
of the insert effect
In the default condition of a project, the insert effect is
applied immediately after the input. To change the insert
location, proceed as follows.
1.
From the main screen, press the [INPUT
SRC] key in the effect section.
The current insert position is shown on the display.
IN SRC IN SRC
IN IN
Insert position
The display meaning is as follows.
ZOOM MRS-8
• IN
Immediately after input (default)
• DRUM
Drum track
• BASS
Bass track
ZNR
• TR 1 - 4
Tracks 1 - 4
PAT LVL
• TR 1/2, TR 3/4, TR 5/6, TR 7/8
Mono tracks x 2 (tracks 1/2, 3/4) or stereo tracks (tracks
5/6, 7/8)
• MASTER
Immediately before [MASTER] fader
2.
HINT
While the screen of step 1 is shown, the status keys and
INPUT [ON/OFF] keys 1/2 can also be used to select the
insert position. To select the track pairs 1/2 and 3/4, press
both status keys together. To select the drum/bass track
using the status key method, press the [RHYTHM] status key
repeatedly until the desired insert position ("DRUM" or
"BASS") is shown.
3.
Selecting the patch for the
insert effect
This section explains how to select the patch for the insert
effect.
1.
The following display is shown. In this condition, you
can select the algorithm and patch for the insert effect.
Turn the dial to select the insert position.
When the desired insert position has been
selected, press the [EXIT] key to return to
the main screen.
From the main screen, press the [INSERT
EFFECT] key in the effect section
repeatedly, until the key is lit.
Reference [Effects]
93