Table 7-1: Types Of Zero /S - Teledyne 9110AH Instruction Manual

TELEDYNE Model 9110AH NO
Table 7-1: Types of Zero/Span Check and Calibration
Section Type of Cal or Check
7.1 Manual Z/S Check or Calibration with
span gas in the sample port
7.2 Manual Z/S Check or Calibration with
Z/S Valve Option.
7.3 Dynamic Z/S Calibration with Z/S
Valves Option
7.4 Use of Z/S Valves with Remote
Contact Closure
7.5 NO Only Mode Calibration
7.6 NO
7.7 Calibration Requirements for
AutoRange or Remote range
7.8 Calibration Requirements for
Independent Ranges
7.9 Calibration Quality
7.10 Converter Efficiency Compensation
Analyzer Operator Manual, 01620, Rev. F
X
Only Mode Calibration
x
Description
This calibration method uses calibration gas
coming in through the sample port. Zero/Span
valves do not operate.
How to operate Zero/Span Valves Option. Can
be used to check or adjust calibration.
Operates Z/S valves periodically and adjusts
calibration.
Operates Z/S valves with rear panel contact
closures. Without valves, can be used to switch
instrument into zero or span cal mode. Used for
either checking or adjusting zero/span.
Covers requirements if calibrating in NO only
mode.
Covers requirements if calibrating in NO
mode.
Covers special requirements if using AutoRange
or Remote Range control.
Covers special requirements if using Independent
Range
Information on how to determine if the
calibration performed will result in optimum
instrument performance.
Covers methods to automatically compensate for
converter efficiency.
7-2
only
x