Honeywell HercuLine 2000 Series Installation, Operation And Maintenance Manual page 69

Actuator Lower
Display
Prompt
LD CAL
LD CFG
RESTRT
* Temperature units are displayed in degrees C or F, and are set by the UNITS parameter. See SET
DISPLA set up group.
† Note that the upper display contains the parameter name and the lower display contains the value.
This is to allow for the display of hours: minutes: seconds.
Revision 7 HercuLine™ 2000 Series Actuator - Installation, Operation and Maintenance Manual
7/08
Selections or
PDA users: The prompts are organized differently on your PDA's
Range of Setting
software. Grayed prompts are under Configuration, Maintenance. Non-grayed
RESTORE CALIBRATION TYPE — Allows you to restore a
NONE
calbration value to its factory calibration.
INP
Input — Restores input calibration to the factory calibration
MTR
for the current configured input type.
COUT
Motor — Restores motor calibration to the factory calibration.
ALL
Output — Restores actuator output calibration to the factory
calibration for the current configured output type.
POS
All — Restores input (for the type configured), motor and
output (for the type configured) calibration to the factory
calibration.
POS — Allows a position sensor field calibration to be stored
as a factory calibration. This is to be used when a sensor is
replaced in the field. See "Calibrate POS Output".
default = NONE
RESTORE DEFAULT FACTORY CONFIGURATION —
DIS
Allows you to restore the factory default configuration.
ENAB
DIS — Restore disabled.
ENAB — Restore enabled.
default = DIS
SYSTEM RESTART — Allows you to force the system to
DIS
restart.
ENAB
DIS — Restart disabled.
ENAB — Restart enabled.
default = DIS
Note: The MANRST function must be set to SYST .
Set Up and Calibration Procedures
Parameter Definition/PDA HercuLink
prompts are under Maintenance.
®
Prompt
HercuLink ®
61