Honeywell HercuLine 2000 Series Installation, Operation And Maintenance Manual page 65

Actuator Lower
Display
Prompt
LREP
LCAL
REPTYP
* NOTE: Date format is set by the UNITS parameter. See SET DISPLA set up group.
Revision 7 HercuLine™ 2000 Series Actuator - Installation, Operation and Maintenance Manual
7/08
Selections or
Range of Setting
DATE OF LAST REPAIR — Factory set only. Displays date
mmddyy *
of last repair.
or
ddmmyy
DATE OF LAST FACTORY CALIBRATION — Factory set
mmddyy *
only. Displays date of last factory calibration
or
ddmmyy
REPAIR TYPE — Factory set only. Displays a repair code to
identify the type of repair service previously performed.
NONE None
01 Future
02 Non-contact Sensor
03 Main CPU PWA repair
04 Motor service
05 Power Distribution PWA service
06 Switch repair
07 Relay service
08 Gear service
09 Service to repair water damage
10 Service to repair damage caused by heat
11 Service to repair due to over-voltage damage
12 Actuator reconfigured
13 Warranty Repair
Set Up and Calibration Procedures
Parameter Definition/PDA HercuLink
Drive Set Up Group
®
Prompt
57