Analysis Mode - Teledyne 3020M Operating Instructions Manual

Percent Paramagnetic Oxygen Analyzer
Setup Mode
AUTO-CAL
PSWD
LOGOUT
Auto-Cal On/Off
Span/Zero Timing
Auto-Cal Start
Establish or
Change a
Password
Log Out and
Enable Security
VERSION
SELF-TEST
S PA N
ZERO
Set Instrument
Display Soft-
ware Version
Perform Self
Diagnostic
Routine
Set Instrument
Span
Figure 4-1: Modes and Functions
4 VERSION: Displays Manufacturer, Model, and Software version
of the instrument.
5 SELF-TEST: The instrument performs a self-diagnostic routine
to check the integrity of the power supply, output boards and
amplifiers.
6 SPAN: Set up and/or start a span calibration.
7 ZERO: start a zero calibration.
8 ALARMS: Used to set the alarm setpoints and determine
whether each alarm will be active or defeated, HI or LO acting,
latching or not, and failsafe or not.
9 RANGE: Used to set up three analysis ranges that can be
switched automatically with auto-ranging or used as individual
fixed ranges.
Teledyne Analytical Instruments

Analysis Mode

ANALYZE
Perform Oxygen
ALARMS
RANGE
CONTRAST
Zero
Set Alarm
Setpoints
Set Alarm
Set Display
Modes of
Operation Contrast
Define Analysis
Ranges
Operation 4
Analysis on
Sample
Contrast Function is DISABLED
(Refer to Section 1.6)
STANDBY
SENSOR
(Not Used)
ON, but No
Displays or Outputs
4-3