Cleaning - Mitsubishi CP8000DW Operation Manual

CLEANING

Cleaning as indicated below will help maintain stable printer operation and extend the
printer's life.
Preparations
Alcohol (isopropyl alcohol)
Tissue paper (Fold in half about 4 times, and use the folded side to clean.)
Cotton buds
Damped cloth or adhesive tape
Other : Cleaner pen (Option)*
* Please ask the dealer about options.
Make sure to turn off the power before cleaning.
1 1 1 1 1
Press OPEN button to open the door.
2 2 2 2 2
Remove the ink cassette.
3 3 3 3 3
Take out the print paper.
4 4 4 4 4
Clean the ink sheet sensor.
Wipe the circled part in the right figure.
Wipe the dust gently with cotton buds etc. which are soaked in a small amount of alcohol.
5 5 5 5 5
Clean the head.
Clean the part below the thermal head which develops heat.
Wipe the head cleaning part carefully with tissue paper etc. which is soaked in a small
amount of alcohol.
• Do not damage the thermal head.
• When the symptom of the poor print quality is not corrected even if the head is cleaned,
replacing the thermal head is required. Contact your dealer.
• Thermal head is hot right after printing. Wait until the head temperature is low when
cleaning the thermal head.
6 6 6 6 6
Clean the paper attachments.
Clean the parts which are the print paper sides as shown right.
Wipe the head cleaning part carefully with tissue paper etc. which is soaked in a small
amount of alcohol.
24
NOTE
A small amount of alcohol
Cleaning part
How to fold tissue paper
Cleaner pen
Ink sheet sensor
Front
Cleaning part of thermal head
Outside
Inside
Cleaning part