Mitsubishi 4G9 series Manual page 80

4G9 ENGINE (E - W) -
Timing mark
When No.1 cylinder is at compression top
dead centre
When No.4 cylinder is at compression top
dead centre
E
Mitsubishi Motors Corporation
"JA SEALANT APPLICATION ON SEMI-CIRCULAR
"KA SEALANT APPLICATION ON ROCKER COVER
(1) Apply sealant to the areas indicated in the illustration.
VALVE CLEARANCE ADJUSTMENT
Adjust the valve clearance by the following procedure.
Adjustment values (when engine is cold):
(1) Turn the crankshaft in the clockwise direction to align
(2) The valve clearances at the places indicated by arrows
(3) Use a thickness gauge to adjust the clearance between
(4) Hold the adjusting screws with a screwdriver so that they
(5) Turn the crankshaft once in the clockwise direction to
(6) Adjust the valve clearances indicated by arrows in the
Dec. 1998
Rocker Arms and Camshafts
PACKING
Specified sealant: 3M ATD Part No.8660 or equivalent
Specified sealant: 3M ATD Part No.8660 or equivalent
Intake valve: 0.09 mm
Exhaust valve: 0.20 mm
the camshaft sprocket timing marks and to set the No.1
cylinder to the compression top dead centre position.
in the illustration can be adjusted.
the ends of the valve stems and the adjusting screws.
do not turn, and then tighten the lock nuts.
set the No.4 cylinder to the compression top dead centre
position.
illustration by the same procedure as in steps (3) and
(4) above.
PWEE9502-E
11A-8-9
Added