Mitsubishi 4G9 series Manual page 78

4G9 ENGINE (E - W) -
Cap No.
IN or EX side
identification
<DOHC - GDI for CARISMA>
Dowel pin
<DOHC - GDI for PAJERO io>
Dowel pin
Approx.
106_
<DOHC - GDI for CARISMA>
3 mm
Beam camshaft cap
<DOHC - GDI for PAJERO io>
Timing belt side
Beam camshaft cap
E
Mitsubishi Motors Corporation
(3) The bearing caps No. 2 through No. 5 are of the same
(4) Make sure that the rocker arms are installed in the
"IA BEAM CAMSHAFT CAP INSTALLATION
(1) Locate the camshaft dowel pin as illustrated.
Approx.
150_
(2) Turn the crankshaft anticlockwise a quarter turn (90_).
(3) Apply a 3 mm thick continuous bead of sealant to the
3 mm
Dec. 1998
Rocker Arms and Camshafts
shape. Before they are installed, check the cap number
and the intake and exhaust identification marks.
Identification mark (stamped on front and No. 2
through No. 5 bearing caps)
L: Intake side
R: Exhaust side
specified locations.
<DOHC - GDI for CARISMA only>
bottom surface of the beam camshaft cap along the
groove.
Specified sealant:
Mitsubishi Genuine Part No. MD970389 or
equivalent
PWEE9502-E
11A-8-7
Revised