Recording Using The Analogue Cable - Sharp MD-SR70H Operation Manual

RECORDING USING THE ANALOGUE CABLE

Recording from CDs or MDs
(Synchro recording)
Synchro recording is a method that detects
the playback sound from the source equip-
ment. When sound is present, it automati-
cally starts the recording. When the source
is silent, the recording will be paused.
1
Connect the external equipment.
(See page 7.)
2
Insert a recordable MiniDisc.
2
1
OPEN
4
3
3
Press the REC button.
To record from a CD or an MD, first
start playing the track you want to
record.
4
Whilst playing sound from the external
equipment connected to this unit, press
the 5 or 4 button to adjust the re-
cording level.
Adjust the recording level so that the
maximum sound volume from the
source makes the reading swing
somewhere between –4 dB and 0 dB.
To record from a CD or an MD, first
adjust the recording level. Then put
the equipment connected to this unit
into the playback stand-by mode.
5
Press the ENTER/SYNC button.
Flashing
6
Begin playback on the source equip-
ment.
Recording will begin automatically.
To interrupt recording:
When the source equipment is stopped,
the unit will enter the synchro recording
stand-by mode. When playback is re-
sumed, a recording will be resumed.
If a silence lasts for 3 seconds or more,
the recording will be paused.
Pressing the 06 button on this unit
(when in this mode) will cause the unit
to enter the recording stand-by mode
and cancel the synchro recording mode.
The track number will be increased by
one each time the recording is inter-
rupted.
To stop recording:
Press the • /:OFF button.
If the unit is left unattended after the
recording is complete, the power will
automatically shut off in approximately
2 minutes.
E-9
0dB
–4dB