Recording From The Radio - Sharp CD-BK3200V Operation Manual

Recording from the Radio

Before recording:
z When recording important selections, make a preliminary test to ensure that the
desired material is properly recorded.
z SHARP is not liable for damage or loss of your recording arising from malfunction
of this unit.
z The volume and sound controls can be adjusted with no effect on the recorded
signal (Variable Sound Monitor).
z For recording, use only normal tapes. Do not use metal or CrO tapes.
Recording can be operated in the TAPE 2 compartment. The TAPE 1 is for playback
only.
1
Tune in to the desired station. (See page 30.)
2
Load a cassette into the TAPE 2 cassette compartment with side A
facing you.
Wind past the leader of the tape, on which recording cannot be performed.
3
Press the button to choose
one side or both sides.
... To record on both sides.
... To record on only one side.
4
Press the REC PAUSE [
(TAPE)] button.
Recording will be paused.
5
Press the ( /SELECT/RESUME) button to record on side A, or
the button for side B.
To record on both sides, begin on side A. (If recording is started from side B, the
tape will not switch over to side A.)
To interrupt recording:
Press the REC PAUSE [ (TAPE)] button.
To resume recording, press the same recording button you pressed in step 5. Other
buttons do not allow resuming.
To stop recording:
Press the ( /RETURN) button.
Note:
If you hear a whistling noise whilst recording an AM station, move the AM loop aerial.
Erase-prevention tab of cassette tapes:
z When recording on a cassette tape, make
sure that the erase-prevention tabs are not re-
moved. Cassettes have removable tabs that
prevent accidental recording or erasing.
z To protect the recorded sound, remove the tab
after recording. Cover the tab hole with adhe-
sive tape to record on the tape without the tab.
Listening to the Radio (See page 30.)
01/5/29 CD-BK3200V(X)E4.fm
CD-BK3200V
Side A
Tab for side B Tab for side A
ENGLISH E-36