Switching On / Off; Switching On The Control; Switching Off The Control; Darkening The Screen - Siemens Sinumerik 810T User Manual

2 Operation

2.2 Switching on / off

2.2 Switching on / off
2.2.1

Switching on the control

Switch on the
main switch on
the machine
?
(( 810T))
(( Bild 2 von Druckerei
einmontieren))
2.2.2

Switching off the control

You switch the control off with the main switch on the machine.
2.2.3

Darkening the screen

The machine tool manufacturer can define in a PLC program whether the screen is to be
darkened. This is intended to prevent the luminescent layer on the screen from wearing out
unnecessarily quickly.
If you select a new display during the dark phase of the screen, e.g. by changing mode, the
screen is displayed again.
2-34
Now operate the "ON" switch!
Possible location of the switch:
• External machine control panel
(2.1.2.1)
• Machine operator panel.
Reaction of the display panel
(2.1.1.2) on the control:
For approx. 1 second the 4 LEDs
are bright and then extinguished
from left to right.
Approx. 10 seconds after switching on,
you will see a display on the CRT in
"JOG" mode, similar to the example
shown here ( e.g. Program "%88").
The control is switched on.
© Siemens AG 1990 All Rights Reserved
09.91
6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)