3 Operating Sequences
3.1.14 "SIMULATION"
SIMULA-
TION
START
The control now simulates the motions programmed on the CRT.
STOP
RESET
3 . 1.14.2 Influencing simulation
The simulation can be influenced so that it is adapted to the program sequence in
"AUTOMATIC mode".
Sequence of operation
PART
PROGRAM
EDIT
3-74
Operate the "SIMULATION" and "START"
softkeys, one after the other.
You can interrupt simulation at any time simply by
pressing the "STOP" softkey.
If you press "RESET" softkey, simulation is aborted.
Operate the "PART PROGRAM" and "EDIT" softkey,
one after the other in any of the operating modes:
PRESET / JOG / AUTOMATIC /
INC FEED 1 .... INC FEED 10 000 / REFPOINT.
© Siemens AG 1990 All Rights Reserved
09.91
6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)