Teach In - Siemens Sinumerik 810T User Manual

3 Operating Sequences

3.2.5 "TEACH IN"

3.2.5 "TEACH IN"
Using the "TEACH IN" function in the "AUTOMATIC" operating mode you can generate a part
program on a block-by-block basis.
You can test the program immediately.
Sequence of operation
AUTO-
MATIC
and
or
...
%
PART
TEACH IN
PROGRAM
PL. BACK
and
The selected part program no. with the input pointer below it are displayed.
...
N
...
G
...
7
X
+
LF
3-116
Operate the operating mode selection key on
the integrated machine control panel, and
then the "AUTOMATIC" softkey
or...
... set the operating mode selector switch on
the external machine control panel to this
symbol.
Enter the desired program no. "% ..." (or
subroutine no. "L ...") in the "AUTOMATIC"
basic display.
Operate the "PART PROGRAM" and
"TEACH IN/PLAYBACK" softkeys, one after
the other.
Using the numerical keyboard, enter a block
(or more than one block) following the
guidelines in the Programming Instructions,
and terminate each input - including "LF"
(end of block) - with the input key.
Note :
You can also work with operator -
"GUIDING" (see Section 3.1.10.2).
The part program is entered directly into the
part program memory.
© Siemens AG 1990 All Rights Reserved
11.90
6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)