More Information - Siemens 2000592-001 User Manual

ANCB Description,
Jumper J5 Settings

More Information

48 • Troubleshooting
Continued
The ANCB jumper settings for J5 are factory set and dependent upon the
product the ANCB will be used in.
Product Type
Advance Network Gateway
Ethernet (ANG-EN)
Advance Network Gateway
DataNET (ANG-DN)
Advance Plus Analyzer
Maxum Analyzers with ANCB/DN
Installed
See ANCB LEDs Description and Operation, page 49.
ANCB J5 Jumper Settings
Pins 3&4 are shorted, switch in 25-
ohm position. 10Base2 connector is
not normally used (not connected)
Pins 1&2 are shorted, switch in 50-
ohm position. 10Base2 connector is
used as an end point for crossover
cable.
Pins 1& 2 are shorted, switch in 50-
ohm position. 10Base2 connector is
used as an end point for crossover
cable.
Pins 3&4 are shorted, switch in 25-
ohm position. 10Base2 connector is
not normally used (not connected)
2000592-001