Siemens 2000592-001 User Manual page 25

DataNET Copper Connections,
Instructions,
continued
2000592-001
Continued
Step
3. Strip the insulation ¼ -inch back from each of the incoming
copper leads.
4. To make the connections easier we have made the ANCB
port connector a removable connector. Grasp the top
portion of the connector and pull it straight out from the
base connector. Loosen all the top wire retaining screws
from the removed connector. All connections will be made
to this connector.
5. Connect Channel A leads to pins 1 through 3 and Channel
B leads to pins 4 through 6. Tighten down the retaining
screws.
6. Plug Port connector back into its base.
Action
DataNET PORT
CONNECTIONS
Pin 1 +
Pin 2 −
Pin 3- Ground
Pin 4- +
Pin 5 −
Pin 6- Ground
Installation • 15