Siemens 2000592-001 User Manual page 53

Command Descriptions,
password
"port" Command
2000592-001
Continued
Example:
local> netstat dn 1
DataNET Statistics for DN link 1
Frames Sent
Frames Sent/Retried
Frames Sent/Redirected
Frames Sent w/ Errors
Frames Sent UnACKnowledged
Frames Received
Frames Receiver Not Ready
Frames Received w/ Errors
Link down
The command netstat hdlc clear resets all DataNET statistics
counters.
The command netstat hdlc 2 clear resets only the port 2 statistics
counters.
The password command is used to change the user assigned password.
The password can be any alphanumeric character and it must be
between five and twenty characters in length. Example:
password newpassword newpassword
Note the newpassword is entered twice to verify that the password was
entered correctly.
This command will enable or disable normal DataNET communication on
individual ports. Before placing a port into "test" mode (see test
command below), the port must first be taken off-line with:
port stop num
where num is a port number, 1 through 2.
port start num
Will re-start normal DataNET communications on a port.
855
0
0
0
0
859
0
0
2
Command Summary • 43