Table of Contents
Advertisement
ADSL Router User Manual
The WAN IP settings page will differ
slightly according to the protocol that
you choose.
This graphic is the one that you will
see if you choose the PPPoE mode in
the previous step. You can select
Enable NAT or change the MTU value
according to your needs.
The next figure following the WAN IP
Settings in the PPPoE mode is shown
at the right. You may refer to the
Quick Setup for further information.
If you choose IP over ATM from the
Connection Type web page, you will
get a web page as the figure.
You may refer to Quick Start-
Connection Type- IPoA section for
more information.
Add Default Route:
Check this item to add a default IPoA
route.
After rebooting your IAD, the default
route will be shown on the Routing
Table under Status menu, you may
check it.
If you choose Bridging from the
Connection Type web page, you will
get a web page as the figure listed at
the right side.
Please refer to Quick Setup for more
information.
78
Advertisement
Table of Contents
