Physical Outlook; Front Panel - Siemens SLI-5310 User Manual

This chapter provides you the description for the LEDs and connectors on the front
and rear surface of the router. Before you use/install this IAD, please take a look at
the information first.

Physical Outlook

Front Panel

The following illustration displays the front panel of this IAD:
LED Indicators
This IAD is equipped with several LEDs on the front panel as described in the table
below:
Function Color
Off
Solid Green
Solid Red
Power
Flash Red
Off
Slow Flash Green
DSL
Fast Flash Green
Solid Green
Off
PPP
Solid Green
Off
Ethernet
Flash Green
Solid Green
Off
USB
Flash Green
Solid Green
Off
Phone 1 or 2
Solid Green
Off
VOIP Ready
Solid Green
Chapter 1: Overview
Definition
Power is off.
Power is on and the device operates normally.
Power on self-test in progress
The device enters the console mode of the boot
loader.
Power on self-test failure if the led always stays solid
red.
Firmware upgrades in progress
No DSL signal is detected.
DSL line is handshaking in progress
DSL line is training in progress
DSL line connection is up.
No PPPoA or PPPoE connection
At least one PPPoA or PPPoE connection is up. The
users can access the Internet now.
No Ethernet signal is detected.
User data is going through Ethernet port
Ethernet interface is ready to work.
No USB signal is detected.
User data is going through USB port
USB interface is ready to work.
The phone is on-hook or in PSTN mode.
VOIP phone call is in use.
Voice over IP service is not ready. The users can
make PSTN phone calls only.
Voice over IP service is ready.
Chapter 1: Overview
1